How to Solve Netgear WiFi Extender Device Light Not On Issue?
It can stress the brain out to another level if the Netgear wireless range extender is on but is not showing any sign that it is. Many users have been complaining about going through this exact thing. In case you too have exhausted yourself trying to find the perfect solution to fix this issue, then you have come to the right place. Here, you will find those fixes that you have not yet implemented to fix the Netgear WiFi extender device light not on issue.
Read them and gain an understanding of how to turn on the light on your networking device. Prior to reading, it is recommended that you keep one thing in mind; there is no need to rush while going through the tips mentioned below as it will not bear any fruit for you. Be patient during the process. Trust us, this will help you out.
Netgear WiFi Extender Device Light Not On Issue [Solved]
1. Confirm If It is an Assumption
The number one reason why you feel that you are stuck with the Netgear WiFi extender device light not on issue is because of an assumption. In case the networking device is located in an area that is under a spotlight from sunlight or compact fluorescent bulbs, then you might not be able to figure out whether the LED light is actually on or not.
To remove all uncertainties, you should keep the extender inside the house where no unwanted light is surrounding it. Now, see if you are still experiencing the same issue. In case you are, then perhaps, it was not just an assumption, but the problem actually exists. In this case, you should follow the next troubleshooting tip in line.
2. Check the Socket in Use Now
Another reason why you are experiencing the Netgear WiFi extender device light not on issue is that the networking device is connected to a wall socket but is not receiving an adequate as well as uninterrupted power supply. This might be because the wall socket is damaged. If not this, then it is probably short-circuited.
You can take the help of two solutions in this case. First case: You need to get the existing wall socket repaired by calling up an electrician. Second case: Plug the Netgear wireless range extender into another wall socket. Make sure that this socket is located in the same room where the host router is kept.
3. Power Cycle the Range Extender
Sometimes, technical glitches can also cause issues related to range wireless extenders. Many users have reported facing the red light issue because of this reason. Chances are that you too are experiencing the Netgear WiFi extender device light not on issue because of the same factor. So, what is needed at this point is for you to power cycle your device.
In order to power cycle the networking device, you need to disconnect it from its wall socket, let it rest for an ample amount of time, and then, connect it back to its wall socket. Now, see if the Netgear extender device light not on issue has left you for good. In case, you still cannot make peace with it, then you should follow the last hack.
4. Reset the Netgear Range Extender
We know that you were dreading not getting to this, but now that you have, you should not waste any more bringing the reset process into action. In order to reset your Netgear wireless range extender, you have to press the reset button on it. But, it is not that simple. In reality, you need to ‘press the button located in a hole’.
And this can only be done if you use an oil pin. Trying to do the same with a pen or bare fingers for that matter will not help you out. Taking this into consideration, do as necessary. Once done, set up your device by referring to the instructions given in the manual. It is the perfect and the most trustable Netgear Genie setup guide to refer to.
Final Thoughts
Here ends the troubleshooting blog post written on how to fix the Netgear WiFi extender device light not on issue. Hope you liked reading it.
